Is this a milled cut for a shoulder stock on a Haenel 28R?
This is milled into backstrap, just seems like a shoulderstock attaching point to me, but never heard or seen one?
Re: Is this a milled cut for a shoulder stock on a Haenel 28
I would be more inclined to think that it is a clearance cut for the magazine knob.
Re: Is this a milled cut for a shoulder stock on a Haenel 28
You are absolutely correct. When you cock the gun it needs that cut out to clear the end. My bad.Leonardj wrote:I would be more inclined to think that it is a clearance cut for the magazine knob.
Re: Is this a milled cut for a shoulder stock on a Haenel 28
Perhaps you could post a picture demonstrating this.
Kind regards,
Phil
Kind regards,
Phil
M0KPH
I now have so many airguns I've had to make a list, which is >>HERE<<
>>North Manchester Target Club<<
I now have so many airguns I've had to make a list, which is >>HERE<<
>>North Manchester Target Club<<
Re: Is this a milled cut for a shoulder stock on a Haenel 28
This shows you should cock the gun before asking dumb questions? Lol