Page 1 of 1

Is this a milled cut for a shoulder stock on a Haenel 28R?

Posted: Sun Oct 23, 2016 12:02 am
by 45flint
Image

This is milled into backstrap, just seems like a shoulderstock attaching point to me, but never heard or seen one?

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Posted: Sun Oct 23, 2016 1:33 am
by Leonardj
I would be more inclined to think that it is a clearance cut for the magazine knob.

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Posted: Sun Oct 23, 2016 1:46 am
by 45flint
Leonardj wrote:I would be more inclined to think that it is a clearance cut for the magazine knob.
You are absolutely correct. When you cock the gun it needs that cut out to clear the end. My bad.

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Posted: Sun Oct 23, 2016 12:19 pm
by pmh
Perhaps you could post a picture demonstrating this.

Kind regards,



Phil

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Posted: Sun Oct 23, 2016 8:17 pm
by 45flint
This shows you should cock the gun before asking dumb questions? Lol
Image