Page 1 of 1
Is this a milled cut for a shoulder stock on a Haenel 28R?
Posted: Sun Oct 23, 2016 12:02 am
by 45flint
This is milled into backstrap, just seems like a shoulderstock attaching point to me, but never heard or seen one?
Re: Is this a milled cut for a shoulder stock on a Haenel 28
Posted: Sun Oct 23, 2016 1:33 am
by Leonardj
I would be more inclined to think that it is a clearance cut for the magazine knob.
Re: Is this a milled cut for a shoulder stock on a Haenel 28
Posted: Sun Oct 23, 2016 1:46 am
by 45flint
Leonardj wrote:I would be more inclined to think that it is a clearance cut for the magazine knob.
You are absolutely correct. When you cock the gun it needs that cut out to clear the end. My bad.
Re: Is this a milled cut for a shoulder stock on a Haenel 28
Posted: Sun Oct 23, 2016 12:19 pm
by pmh
Perhaps you could post a picture demonstrating this.
Kind regards,
Phil
Re: Is this a milled cut for a shoulder stock on a Haenel 28
Posted: Sun Oct 23, 2016 8:17 pm
by 45flint
This shows you should cock the gun before asking dumb questions? Lol