Is this a milled cut for a shoulder stock on a Haenel 28R?

A place to discuss and share pictures, reviews, of your pistols.
Post Reply
45flint
Plinker
Plinker
Posts: 68
Joined: Tue Feb 09, 2016 12:50 am

Is this a milled cut for a shoulder stock on a Haenel 28R?

Post by 45flint » Sun Oct 23, 2016 12:02 am

Image

This is milled into backstrap, just seems like a shoulderstock attaching point to me, but never heard or seen one?

Leonardj
Marksman
Marksman
Posts: 128
Joined: Sun Dec 23, 2012 4:58 am

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Post by Leonardj » Sun Oct 23, 2016 1:33 am

I would be more inclined to think that it is a clearance cut for the magazine knob.

45flint
Plinker
Plinker
Posts: 68
Joined: Tue Feb 09, 2016 12:50 am

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Post by 45flint » Sun Oct 23, 2016 1:46 am

Leonardj wrote:I would be more inclined to think that it is a clearance cut for the magazine knob.
You are absolutely correct. When you cock the gun it needs that cut out to clear the end. My bad.

User avatar
pmh
Site Admin
Posts: 1811
Joined: Sat Nov 10, 2012 5:07 pm

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Post by pmh » Sun Oct 23, 2016 12:19 pm

Perhaps you could post a picture demonstrating this.

Kind regards,



Phil
M0KPH
I now have so many airguns I've had to make a list, which is >>HERE<<
>>North Manchester Target Club<<

45flint
Plinker
Plinker
Posts: 68
Joined: Tue Feb 09, 2016 12:50 am

Re: Is this a milled cut for a shoulder stock on a Haenel 28

Post by 45flint » Sun Oct 23, 2016 8:17 pm

This shows you should cock the gun before asking dumb questions? Lol
Image

Post Reply